MyG37 - 63mm Bored TB's idle

MyG37 (https://www.myg37.com/forums/)

- Intake and Exhaust (https://www.myg37.com/forums/intake-and-exhaust-328/)

- - 63mm Bored TB's idle (https://www.myg37.com/forums/intake-and-exhaust/294659-63mm-bored-tbs-idle.html)

Dzionassi

Nov 2, 2019 05:45 PM

63mm Bored TB's idle

Installed these yesterday, after install was idling at +-1000rpm's . Did a relearn procedure with Ecutek got it down to 720-750.
If I remember correctly, I was at 650 or so before install...
Question is... what is normal idle with 63mm TB's?

jpowersjr2

Nov 3, 2019 08:52 PM

Not sure about that but you might need a re-tune.

Surfnazi

Nov 6, 2019 02:27 PM

You'll need a tune bc it's out of delta range for stock af

Dzionassi

Nov 6, 2019 02:34 PM

Quote:

Originally Posted by Surfnazi (Post 4259981)

You'll need a tune bc it's out of delta range for stock af

Log's looking OK...

Surfnazi

Nov 11, 2019 05:23 PM

Does log show full range of rpm

Dzionassi

Nov 11, 2019 11:07 PM

Quote:

Originally Posted by Surfnazi (Post 4260316)

Does log show full range of rpm

up to 7463rpms

Surfnazi

Nov 12, 2019 09:07 AM

Post up the log

Dzionassi

Nov 12, 2019 10:01 PM

1 Attachment(s)

attached

bythabay

Nov 14, 2019 04:06 AM

Knock sensitivity has been raised significantly (the ECU has been made more "deaf" to knock events).
AFRs are all over the place.
It's running pretty much stock timing or less than what it would run stock.

What fuel are you running? What other mods does this car have? Is this a rebuilt engine?

https://cimg1.ibsrv.net/gimg/www.myg...9cc84af716.jpg

https://cimg3.ibsrv.net/gimg/www.myg...bc76b7c64f.jpg
https://cimg5.ibsrv.net/gimg/www.myg...4999fe5a4d.jpg

All times are GMT -4. The time now is 12:44 PM.