ART pipe Hardware
#1
Registered Member
Thread Starter
ART pipe Hardware
I recently bought some Motordyne ART pipes used so I don't have hardware. Getting ready to install but am missing some hardware. I've already purchased the 3 bolt Z1 gaskets (cat to header) and replacement OEM 2 bolt gaskets (cat to y-pipe). The only thing I don't have is the bolts and nuts for the cat to header side. Does anyone have the specs of the nut and bolt sizes for the 3 bolt side of the ART to header side that need to be used? Thanks in advance.
The following users liked this post:
Kpmikey808 (06-30-2020)
#3
Registered Member
iTrader: (5)
First off the ART pipes use the oem ring gasket and you should NOT be using the z1 gasket for the header.
second take a pipe with you to hardware store find stainless bolts that fit in the hole and correlating nuts. Make sure they'e stainless. For one bolt on each side you reuse oem nut as the stud is on the header not removable for install so you just need 4 bolts and corresponding nuts. Get bolts and nuts with 14mm or so head.
second take a pipe with you to hardware store find stainless bolts that fit in the hole and correlating nuts. Make sure they'e stainless. For one bolt on each side you reuse oem nut as the stud is on the header not removable for install so you just need 4 bolts and corresponding nuts. Get bolts and nuts with 14mm or so head.
#4
Registered Member
Thread Starter
I notice you just listed yours (ART pipes) for sale in classifieds. Mind me asking why you're getting rid of them so quickly? Also curious for the reasoning for not using the Z1 gaskets and what is the intended purpose of the Z1 gaskets?
The following users liked this post:
QuinnDEskimo (02-16-2018)
The following users liked this post:
QuinnDEskimo (02-16-2018)
#7
Registered Member
Thread Starter
Ahhh, I see. Thank you! I'll have to take a look at them when I get home now. Don't be surprised if you see an ad for (2) Z1 header to cat metal gaskets in the classifieds soon. (they weren't cheap either).DOH!
Trending Topics
The following users liked this post:
QuinnDEskimo (02-16-2018)