how hard is it to install factory OEM rear deck spoiler?
#32
Registered Member
I just did my 2013 g37s coupe, and have the 15 page installation instruction book, and the templates. I was very careful, and the job took about 1.5 hours. I used some zinc paint and a small brush to add a bit of rust prevention around each hole after deburring. I used two Milwaukee bimetal hole saws for the 18 and 19 mm holes, or 11/16 and 5/8. The outer 18 mm holes you have to be particularly careful as to not drill though. The wiring for the spoiler third brake light was already in the loom, so I just disconnected the third brake light connection under the package shelf. The part number for the new gas shocks is 84430-JL00B. PM me your address and I will send you the instructions and templates.
#33
Registered Member
yOU ARE ALSO GOING TO NEED 2 X NISSAN 0155309621 GROMMETS That push into the holes out towards the tips of the spoiler. New 3m double tape is also a must to attach the spoiler to the body.
Thread
Thread Starter
Forum
Replies
Last Post
superjoey
D.I.Y. Installations/Modifications
31
03-22-2023 11:56 PM
SpeedBallDEVIL
Private Classifieds
3
08-12-2015 04:30 PM