Help Check Eng Lights wont turn off... help!
04-15-2018, 05:03 PM
#1
Check Eng Lights wont turn off... help!
My mechanic is hooking up his scanner to the OBD and trying to remove the code which is a 010 code... and he is resetting the code and canceling out the 010 code and the engine lights are NOT turning off.. ABS, AWD, traction, check engine are all on and WONT TURN OFF... how in the heck can we get these codes off??? this is the 2nd mechanic to try and turn off the codes... uggh. 
thx,
thx,
04-15-2018, 06:31 PM
#2
Registered Member
You probably have a P0010 code for bank 1 camshaft position. The code will not erase if the problem is not corrected. Possible issues:
Engine timing out of sync, Engine oil sludge or lack of oil or oil pressure. Worn timing components (chains, gears, guides)
Crankshaft or camshaft sensor malfunctions
Wiring damage
ECM software out of datA ECM internal damage
Engine timing out of sync, Engine oil sludge or lack of oil or oil pressure. Worn timing components (chains, gears, guides)
Crankshaft or camshaft sensor malfunctions
Wiring damage
ECM software out of datA ECM internal damage
04-16-2018, 10:11 AM
#4
I also have that code and was easily able to clear it. You have to be sure to turn the engine off when you clear it. I also started a thread about replacing the solenoid as i had troubling trying to get it out, otherwise it's a simple remove and replace.
04-16-2018, 11:05 AM
#6
04-16-2018, 11:06 AM
#7
when he reset the codes the car was "on" but not running.... then we turned the car off. cranked engine and they were all still on. nothing went out. are you saying car should be "off" when codes are reset? or just turned off once reset? thx
Trending Topics
The following users liked this post:
monytx (07-25-2018)
Thread
Thread Starter
Forum
Replies
Last Post
Blodngutz
Body Interior Exterior Lighting
0
11-10-2017 10:41 AM
Foxtrot_01
Engine, Drivetrain & Forced-Induction
7
01-31-2013 03:59 PM