Show me your cam phasers
Help me. Would you show me your camshaft phasers ?
Pulled both cam covers off the g37 (2013 with 52k miles) to inspect the cam phasers. Why ? Long story short. --> The g37x went dead 2 blocks from the house a few months ago - no warning. Code P0340 popped up. Only code. Replaced Camshaft Position Sensor on Right (passenger - Bank 1) with new one from Infiniti. Car would just turn over fine but never start (with battery coming off a full charge and checked good). Pulled CPS connector off - car started but ran very rough. Towed it to the dealer. Dealer says he needs $6k for new engine. I say f**k you all. I'm outta here. Check for similar problem online and found the link to Jim Wolfe Technology. http://www.jimwolftechnology.com/wol...derslipped.pdf https://cimg9.ibsrv.net/gimg/www.myg...cf1b0f36c4.jpg Can you guys look at my intake cam decoder ring and say its moved any ?? =-This is the intake side cam sprocket the one which threw the code. The exhaust side looks like this: https://cimg7.ibsrv.net/gimg/www.myg...1c4edcc793.jpg just wondering if anyone has had experience with these things shifting and having to replace them. Thanks ! |
if we're jsut looking at pictures and comparing, yours look slipped. lol
|
No experience. And we can't tell unless both the rotor and the front cam lobe is visible.
|
Based on comparing with the photos from JimWolfe Technologies - I think both of the phasers may have shifted ???
|
Are Wolf's at stock position?
|
I'm not sure. I dont have anything else to go off of.
Looking to see if I can find any good shots from youtube vids. - or if anyone has their motor taken apart and could post a pic or two. P. |
Originally Posted by markops2002
(Post 4182930)
I'm not sure. I dont have anything else to go off of.
Looking to see if I can find any good shots from youtube vids. - or if anyone has their motor taken apart and could post a pic or two. P. |
Tod - I posted in https://www.myg37.com/forums/engine-...g-weird-2.html
a few months back. Check it out. |
Update on an old thread. I feel like whoever can post pictures of their cam encoder wheels at TDC would help the rest of the community tracking down on this pesky code.
|
Does this look slipped?
https://cimg2.ibsrv.net/gimg/www.myg...ae03c81f0.jpeg
I been getting a pending 0021 and 0524 code for a year now, after it first started i did the galley gaskets. Mechanic said everything else looked fine. Worked great for 2 months then i got the pending p0021 code intermittently twice a month and then would go away. Never a check engine light. Now it started to feel like i lost a lot of power, and now i got the service engine soon light and the p0021 and p0524 codes were finally confirmed. I took off the vtc cover today does the ring look slipped? |
Hard to see in this pic however the 2 teeth leg seems to be in a different position than the one I took a pic of when I did mine's. You'd need to confirm with other's on bank two to confirm. Most pictures I find are of bank 1
https://cimg4.ibsrv.net/gimg/www.myg...003247e0f6.jpg |
What two tooth leg are you talking about? On the phaser itself?
|
Cam phaser
Hey bro, you ever figured out the issue? I have the exact same issue as you right now and can’t figure it out but my cam phaser looks just like yours.
|
All times are GMT -4. The time now is 10:20 PM. |
© 2024 MH Sub I, LLC dba Internet Brands