QX56/Titan 5.6L V8 Engine swap Q's
#47
Registered User
Join Date: Jul 2008
Location: your moms room watching TV
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
I know its not the cheapest route or most practical but it would be bad a$$
I had looked into this before building my 3.8L TT G35. I wish i would have done the VK56 swap instead.
One of the issues the G35 guys ran into was the intake plenum wouldn't clear the hood, so a cowl or custom intake with shorter runners would be required I assume the G37 would have similar issues. I would do it and run a couple of GT-30s or GT-35s on the stock bottom end it would be a monsTTer.
This thing sounds so sickkk
http://www.youtube.com/watch?v=gOtYO...layer_embedded
I had looked into this before building my 3.8L TT G35. I wish i would have done the VK56 swap instead.
One of the issues the G35 guys ran into was the intake plenum wouldn't clear the hood, so a cowl or custom intake with shorter runners would be required I assume the G37 would have similar issues. I would do it and run a couple of GT-30s or GT-35s on the stock bottom end it would be a monsTTer.
This thing sounds so sickkk
http://www.youtube.com/watch?v=gOtYO...layer_embedded
#48
Administrator
I met a guy actually who did a 2JZ engine swap on his G35. That thing drove INSANE!
Didn't cost much either, used 2JZ engine + labor only costed him around 4 grand!!!!
Didn't cost much either, used 2JZ engine + labor only costed him around 4 grand!!!!
#50
Registered User
iTrader: (9)
I know its not the cheapest route or most practical but it would be bad a$$
I had looked into this before building my 3.8L TT G35. I wish i would have done the VK56 swap instead.
One of the issues the G35 guys ran into was the intake plenum wouldn't clear the hood, so a cowl or custom intake with shorter runners would be required I assume the G37 would have similar issues. I would do it and run a couple of GT-30s or GT-35s on the stock bottom end it would be a monsTTer.
This thing sounds so sickkk
YouTube - Supercharged V8 G35 Drifting
I had looked into this before building my 3.8L TT G35. I wish i would have done the VK56 swap instead.
One of the issues the G35 guys ran into was the intake plenum wouldn't clear the hood, so a cowl or custom intake with shorter runners would be required I assume the G37 would have similar issues. I would do it and run a couple of GT-30s or GT-35s on the stock bottom end it would be a monsTTer.
This thing sounds so sickkk
YouTube - Supercharged V8 G35 Drifting
#51
Administrator
#54
Banned
iTrader: (13)
I wonder if we can stick LS2's in the G37 LOL. I know they do it to 350z no problems, perhaps we could even get a new motor than the ls2s!
YouTube - engine view of the ls2 350z
YouTube - LS2 350z take off
imaging that shiiiiet!
or this!
YouTube - Noah's 350Z 1
I swear if I had my g35 I would so stick a v8 in one for fun and push the limits.
YouTube - engine view of the ls2 350z
YouTube - LS2 350z take off
imaging that shiiiiet!
or this!
YouTube - Noah's 350Z 1
I swear if I had my g35 I would so stick a v8 in one for fun and push the limits.
#55
Administrator
Owner of that G35 would abuse the shiat out of that engine till it blows, then get another one for less than a grand lol
#58
Administrator
RBs and JZs seem to be the way to go here
#59
Banned
iTrader: (3)
Join Date: Aug 2007
Location: Montreal
Posts: 6,437
Likes: 0
Received 0 Likes
on
0 Posts
I wonder if we can stick LS2's in the G37 LOL. I know they do it to 350z no problems, perhaps we could even get a new motor than the ls2s!
YouTube - engine view of the ls2 350z
YouTube - LS2 350z take off
imaging that shiiiiet!
or this!
YouTube - Noah's 350Z 1
I swear if I had my g35 I would so stick a v8 in one for fun and push the limits.
YouTube - engine view of the ls2 350z
YouTube - LS2 350z take off
imaging that shiiiiet!
or this!
YouTube - Noah's 350Z 1
I swear if I had my g35 I would so stick a v8 in one for fun and push the limits.