DIY: Serpentine belt change on an 09 G37
#91
Registered Member
All the other pulleys have been replaced. The grinding noise is coming from the belt tensioner.
How do you know it's the tensioner? Does the pulley spin freely without and binding, grinding or other peculiarity? Did you check other pulleys for issues?
^^Ordered 2 different flush valves on amz (goes into the bottom part of a typical family home toilet). One was a generic unit, other was advertised as oem.
Upon arrival, both looked identical, down to the same manufacturer's product number markings. The only difference was the cheaper one was shipped in a single layer box (think slightly thicker than a postcard), the oem was shipped in a double corrugated box. Of course one was 2x cost of the other.
tl;dr I'd think twice about buying auto parts on amazon.You don't really know what you're getting until in hand.
^^Ordered 2 different flush valves on amz (goes into the bottom part of a typical family home toilet). One was a generic unit, other was advertised as oem.
Upon arrival, both looked identical, down to the same manufacturer's product number markings. The only difference was the cheaper one was shipped in a single layer box (think slightly thicker than a postcard), the oem was shipped in a double corrugated box. Of course one was 2x cost of the other.
tl;dr I'd think twice about buying auto parts on amazon.You don't really know what you're getting until in hand.
Thread
Thread Starter
Forum
Replies
Last Post
2009G37Bandit
G37 Sedan
32
01-10-2013 02:46 PM
DetailersDomain
Car Care & Detailing
3
07-26-2012 01:20 PM