teahead

This one for $410?


Or this one for almost $200 more!

Entcee

iTrader: (3)

Pretty sure both would be adequate. The more expensive one may have wider or different adjustability (have not looked as specs). But, if you plan on going really low, I would probably go with the more expensive one. Really low ride height paired with soft springs/shocks could cause the arm to hit the upper fender in the wheel well. This is because the adjusting cam / joint is bigger than OEM causing the arm to be "taller" and have less clearance. The more expensive ones have a much lower profile in the ball joint area.

That said, I think most go with the cheaper set.

teahead

Plan on going w/BC Racing coilovers, but I don't want it that low. Maybe 1.5" lower than stock.

teahead

I think for $200 more, I think it's worth it to me since it has a lot less likely chance to slip out of adjustment, unlike the cheaper arms, where it's adjustment is one single bolt/nut.

Baadnewsburr

iTrader: (3)

I think most people get the cheaper ones and if they want to spend more they get the SPL arms which are an even better design: https://www.z1motorsports.com/suspen...37-p-7360.html so most people dont seem to go for the more expensive SPC arms

SupraOfDoom

Could be bad luck/my roads but my ball joints ended up having play very shortly after install on the cheaper SPC's. If I were to do it again I'd just get the SPL, especially since you can adjust the camber without removing anything.

MerakiAutoworks

iTrader: (1)

Always go with SPC! So you don't ruin into issues. Suspension is very important.

-Josh

Crusher103

Well currently i have Kinetix A arms. I am not in love with the design. I was in a time crunch and they could get me the arms the fastest, so i bit the bullet. But contrary to popular believe they are decent A arms. Adjusting them is a bitch but i set them once and forgot about them. Have not given me any trouble. Took my car up in the mountains had a blast no issues. That said, my car is a pure street car. I do not intend on putting slicks or any kind of truly high performance tire on it. If i was then i would be looking at SPLs or Voodoo13 A arms.

slartibartfast

iTrader: (7)