What the heck is this in the pic? Is this what everyone is rubbing on?
 

I dont have a clue what it is for... Anyone???? Is this what everyone rubs when lowered or Wide wheels? Its the bracket thingy with 2 holes in it... for those who dont have a clue what I'm talking about...




http://i254.photobucket.com/albums/h...2/DSC00730.jpg
http://i254.photobucket.com/albums/h...2/DSC00731.jpg
http://i254.photobucket.com/albums/h...2/DSC00732.jpg

i have no clue what is that. it rubs your tires? sounds bad..

Haha that actually had me worried so I just checked. I have the same thing, no idea what its for but its about 2-3 inches away from my wheels (20x10.5 +36 rears) and that would never touch it. Took a picture but phone is being stupid so can't upload it.

I noticed that when they put my car on the lift to install the HFCs. I forgot about it until you posted these pics.

here is a picture of how far it is from my wheels.

http://i282.photobucket.com/albums/k...k84/noname.jpg

blah I need wider tires next time, 275's just don't cut it on a 10.5 wheel, 295's or 305's next time :D

look under the car, there are all sorts of brackets back there not being used

I wanna know what everyone was talkin about grinding down... Sharif...Solo? I think both of you all know or have done it.... What was it?

No you wont come close to that piece. I had to grind the tab that is on the inside of the fender that holds the fender to the bumper. If that makes sense.

if you can snap a pic... that would be great!! thanks bro!

Prolly not cause I would have to take my wheel back off and I dont plan on doing that until my new sensors come in. If you can wait a week or so but I dont think you can.

maybe someone will snap and pic of where its and and you can explain it then... dont take you wheel off just to take a pic tho... its not that big of a deal... Ill find out sooner or later somehow...

Just reach up inside the wheel well near the top but then a little back where the bumper and fender meet. There is a tab and a screw or bolt in it that hold the 2 sections together. You can't miss it if you run your hand around the edge of the inside of the well.

I know what you mean now....and you grinded the head of the bolt down?

look where the fender / bumper meet..

where the bolt is, there is both fender and bumper. but in front of the bolt, towards the wheel, it's just fender. that's what i took off