Calling nav swappers

Reply Subscribe

Thread Tools

Search this Thread

01-03-2020, 12:00 PM

#46

ILM-NC G37S

Registered Member

iTrader: (3)

Join Date: Apr 2014

Location: NC

Posts: 4,073

Likes: 263

Received 1,253 Likes on 1,015 Posts

The confusion is that during playback, UP skips to the next station/track and DOWN is previous...,BUT, when scrolling through a station/track list, UP is previous while DOWN is next.

Reply Like

01-03-2020, 12:08 PM

#47

dookie

Registered Member

Join Date: Aug 2009

Posts: 17

Likes: 2

Received 0 Likes on 0 Posts

Quote:

Originally Posted by ILM-NC G37S

The confusion is that during playback, UP skips to the next station/track and DOWN is previous...,BUT, when scrolling through a station/track list, UP is previous while DOWN is next.

Got it. I was probably overthinking it... Although I hate it when software devs aren't consistent (note: i'm a SW dev)

Reply Like

01-03-2020, 02:50 PM

#48

dookie

Registered Member

Join Date: Aug 2009

Posts: 17

Likes: 2

Received 0 Likes on 0 Posts

Quote:

Originally Posted by ILM-NC G37S

Not sure how much help I can provide as I have a 2018 steering wheel, but, looking over my notes there are only three (3) wires going from the headunit to the steering wheel switches:

You may want to double check that you have those three (3) wires in the right place.

HOWEVER, as was mentioned previously, you should have a 2010+ preset switch assembly ("faceplate") to match your headunit. This could be the cause of your issues. I doubt your steering switches are the problem as, like I said earlier, I have a 2018 steering wheel and those switches work fine with the 2014 headunit.

Also, UP is for the NEXT track, DOWN is for previous. Always been this way AFAIK.

Re-examing the wiring diagram, the Vol up/down phone, and back buttons are all on the same wire going into the av control unit. (pin 16 on both the 07 M80 and 2010 M208 connectors). I wouldn't be surprised if I have a wiring issue with pin 16. Going to have to go disconnect everything and check the output.

Reply Like