When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
hey beast do you have any problems with speed bumps or scraping at that height? I'm thinking of dropping my car about that low but don't want to deal with scraping issues
i noticed that on the rear that the height adjusters will only allow you to get to the point where the tires start tucking. the fronts can pretty much slam to the ground though.
damn very clean car... those drop looks good. Since you dumped the car with those tanabe, are there any issues? How are they holding up. And I know more you dump the car the more stiff or bouncy it'll be... how is the tanabe coil holding up on your condition?
well i got my car aligned today, i don't have the actual before specs (i got a printout with BS numbers so that I can pass recon), but the front cambers were like 2.7 degrees, and the rear cambers were something like 3.4 degrees. this is with zero gap from fender to tire for both front and rear. the rear camber was able to be adjusted close to, but just out of the specified OEM range. toes are all within factory specs, which is what i was most worried about. time to save up for them spc camber kits.