My new ramps
#1
Registered Member
Thread Starter
iTrader: (1)
My new ramps
Hey guys, just wanted to share a couple of picture of my new cool ramps
I have the Eibach kit installed and to lift the front-end I always needed to use a scissor jack under the pinch weld to lift one side enough to then get my low profile jack under the center lift point.
Finally, last week decided to look for something simple but very useful.
For under $50 shipped I thought it was a great deal.
I got a pair of plastic car ramps with a 4,400Lb capacity.
They are really nice and they clear the front bumper.
Perfect height, I was able just to drive up the ramps and slide my jack under the center lift point with almost 1" to spare to the highest point of the jack.
They are about 5Lbs each so they are super easy to put away when done with the project.
Anyways, cheers
I have the Eibach kit installed and to lift the front-end I always needed to use a scissor jack under the pinch weld to lift one side enough to then get my low profile jack under the center lift point.
Finally, last week decided to look for something simple but very useful.
For under $50 shipped I thought it was a great deal.
I got a pair of plastic car ramps with a 4,400Lb capacity.
They are really nice and they clear the front bumper.
Perfect height, I was able just to drive up the ramps and slide my jack under the center lift point with almost 1" to spare to the highest point of the jack.
They are about 5Lbs each so they are super easy to put away when done with the project.
Anyways, cheers
The following users liked this post:
properdropper (09-06-2015)
#3
Registered Member
Hey guys, just wanted to share a couple of picture of my new cool ramps
I have the Eibach kit installed and to lift the front-end I always needed to use a scissor jack under the pinch weld to lift one side enough to then get my low profile jack under the center lift point.
Finally, last week decided to look for something simple but very useful.
For under $50 shipped I thought it was a great deal.
They are about 5Lbs each so they are super easy to put away when done with the project.
Anyways, cheers
I have the Eibach kit installed and to lift the front-end I always needed to use a scissor jack under the pinch weld to lift one side enough to then get my low profile jack under the center lift point.
Finally, last week decided to look for something simple but very useful.
For under $50 shipped I thought it was a great deal.
They are about 5Lbs each so they are super easy to put away when done with the project.
Anyways, cheers
Thread
Thread Starter
Forum
Replies
Last Post
Badgerman
Engine, Drivetrain & Forced-Induction
2
08-19-2015 02:26 PM