STOOF

iTrader: (2)

Just found this carbon one for a few bucks cheaper.

09-10 Infiniti G37 Carbon Cabin Air Filter NEW Vent AC : eBay Motors (item 160419621182 end time May-01-10 1331 PDT)

Danny@Limited Edition

iTrader: (4)

^Funny fact: I visited TYC (manufacturer of that filter) overseas. Their headlight department is legit! Deals straight to Scion for aftermarket options!

chasemyaccord

iTrader: (2)

Good to hear. I just bought a filter from them off eBay. ~$21 with eBay 8% Bing CB and eBay bucks

Oggie

iTrader: (2)

Great writeup. I just done my today. Thanks.

G_iantkiller

I installed a TYC charcoal filter this weekend, but I'm having some doubt as to whether I installed it properly. The instructions that came with the filter said that the arrow should be pointed DOWN, but I ran across this link that indicated the filter should be installed with the arrow pointed UP:
In Cabin Micro Filter Replacement Procedure Infiniti G35 / G37 Sedan

How have you guys installed your replacement filters? Thanks a bunch, guys.

hispeed-lowdrag

iTrader: (7)

If I remember right the arrow is pointing UP. In any case, go with the instructions for the specific car, not the filter.

G_iantkiller

Thanks. What is confusing me is that the instructions included with the filter are specifically for the Infiniti. Still very confusing. I may try to find a service manual for our cars, which might help.

Gamedog

iTrader: (9)

BUMPN this thread to say thanks to Redline for posting this DIY

Finally got around to doing this after 57K miles haha

Redline37

iTrader: (2)

Glad It could help gamedog!

Ahujadaddy

^^ yea man, thank you. i did this a couple months ago myself. light and filter. glovebox was a PITA for me >_< easy, just annoying.

i liked my old corolla, lol... just squeeze the sides of the glovebox and pull down. slide filter out, new one in... glovebox squeeze back in and you are done! 5 min

CS130PS

Thanks for the DIY. Just replaced my glove box light to led. Looks awesome! Worth every minute

johnbrnrd

DOMO thanks for the DIY tutorial. might check up my ACC cabin filter later and the glove box light (this one doesn't work anymore) anyway thanks Redline37

woodG37

How difficult/easy is it to put everything back? Do I need any special tool to take out the side panel? Thanks!

Kidcane

iTrader: (7)

Thanks! Finally did this. Super easy. Good write up. ^^Very easy to put back together and the side panel just snaps off. No tool needed.

rwong410

Does anyone have a picture of the damper pin from another angle? I can't seem to locate it