Reference was just for a guide. Removing seat from car and taking cover off is basically the same on most all bucket seats.
Remove the little plactic covers on the mounting rails that cover mounting bolts(4 of them) unplug the wiring. Get the seat out on a bench(much easier than working with it on the floor) there are plastic strip clips that keep the cover attached around the outer edges, roll them off. Then the hog ring that hold the cover down to the cushion in the middle area are the tricky part. There mostly not reusable, so clip them with side cutters, then the cover will come off. Steaming the cushion to renew it gets mixed reviews, consider a new one. For reinstalling the cover, Hobby lobby or a upholstery shop or supply will have the hog rings( some say use heavy duty zip ties instead) I didn't, also crimping the hog rings really takes hog ring pliers( Hobby lobby or the shop). Again the reattachment of the cover with the hog rings was the hardest part, upholsterers that do it every day, its easy for them. Roll the plastic clips back on and reinstall seat.
For a complete detail. Check out the FSM section: se : pages 166/175. That's a 13 coupe FSM. Nicoclub.com
Last edited by z 2 g; 11-28-2016 at 10:34 PM.