Review JDP CF Spoiler Add on from Amplified!!!
#20
Registered User
Join Date: Mar 2010
Location: Central NJ
Posts: 332
Likes: 0
Received 0 Likes
on
0 Posts
That Hood is VERY NICE... Does it work well to cool down the engine?
I notice sometimes pulling in my garage after a long ride, the temp goes up
easily 15 degrees... Besides looking so F'n Tight! Did you install yourself?
Oh, BTW HiSpeed... When I lived in TX (Early 90s) they had front plates... The kill that now?
JC
I notice sometimes pulling in my garage after a long ride, the temp goes up
easily 15 degrees... Besides looking so F'n Tight! Did you install yourself?
Oh, BTW HiSpeed... When I lived in TX (Early 90s) they had front plates... The kill that now?
JC
#21
That Hood is VERY NICE... Does it work well to cool down the engine?
I notice sometimes pulling in my garage after a long ride, the temp goes up
easily 15 degrees... Besides looking so F'n Tight! Did you install yourself?
Oh, BTW HiSpeed... When I lived in TX (Early 90s) they had front plates... The kill that now?
JC
I notice sometimes pulling in my garage after a long ride, the temp goes up
easily 15 degrees... Besides looking so F'n Tight! Did you install yourself?
Oh, BTW HiSpeed... When I lived in TX (Early 90s) they had front plates... The kill that now?
JC
Texas actually still has front plates, but since I don't live in Texas, I refuse to put the front plate on. One of the benefits of being in the military is that i can register my car in a different state than where i live (I picked TX so that i don't have to pay state income tax lol)
#24
It's just you.
haha jK the Seibon hood sits a little higher up so you either have to remove the middle spring, which will allow it to sit flush, or leave it and have that super small gap in front (its ~1/4 inch)
the only downside to removing the spring is that you can no longer open the hood by yourself, since there is nothing to push it up. so either way there are pros and cons
haha jK the Seibon hood sits a little higher up so you either have to remove the middle spring, which will allow it to sit flush, or leave it and have that super small gap in front (its ~1/4 inch)
the only downside to removing the spring is that you can no longer open the hood by yourself, since there is nothing to push it up. so either way there are pros and cons
Thread
Thread Starter
Forum
Replies
Last Post
RexHavoc
Private Classifieds
4
10-02-2015 11:47 AM